INSTALLATION INSTRUCTIONS

Adhesive

SCOPE:  Adhesive mounting is ideally suited for applications requiring speed and ease of installation or flexibility to adjust to various field conditions.  This type of installation requires no layout time for the installer due to the random application of adhesive to the panels

1. Wall surface to be clean and free of any surface obstructions.

2. Install leveling angles (supplied w/ panels) using appropriate mechanical fasteners.

   ***DO NOT INSTALL PANELS WITHOUT LEVELING ANGLES***

   The leveling angles are the primary panel support.  If panel installation is from “floor up” leveling angles are not required.

3. Prepare panel for installation. Mark back of panel for field cutting (if required. Carefully cut fiberglass from back of panel. Then cut the covering surface leaving enough covering to allow for wrapping of the field cut area. Carefully apply adhesive to the cut-out fiberglass edges and panel back then fold the excess covering around the cut-out area edges and wrap the back of the panel.

4. Apply “spots" (approx. 4 x 6 “ diameter) of panel mounting adhesive at random locations around perimeter and across the vertical and horizontal centers of the panel.

5. Position the panel on the leveling angle and press the panel to the wall to set adhesive. Hold until adhesive sets.

NOTE: These instructions serve only as a guide. As there are many variable field conditions, the responsibility for recognizing these conditions and compensating for them lies with the installer.